Pink® Batts® Insulation: Retrofitting a Skillion Roof using Ultra R4.0 140mm Wall

Although retrofitting a skillion roof is not as common as retrofitting a pitched roof, you can retrofit a Skillion roof under these scenarios:
- From the outside, when the roof cladding is going to be changed; or
- From the inside if the rafters are exposed.

Recently we got involved on a retrofitting job with exposed rafters. 

The customer was after the highest possible R-value that could be installed. They understood that the highest amount of heat loss goes through the roof in an uninsulated house and that it wouldn’t be practical to try and add a top up later on.  

There was no need to leave an airgap as the rafters’ depth was 140mm and the insulation was going to be installed in between the GIB plasterboard (the old one and the new one).

 

What did we recommend?

Pink® Batts® Ultra® R4.0 Wall – 140mm.

  • Due to its higher density, Pink® Batts® wall products can be used in either ceiling, wall or underfloor scenario.
  • Highest R-value suitable.

Other alternatives were:

Both alternatives would have worked, but Pink® Batts® Ultra® R4.0 Wall delivers the highest thermal performance in this scenario and best meets the clients requirements.

Download product datasheets and installation instructions  and contact customer@pinkbatts.co.nz for advice on your project. 

1. Before skillion renovation started:

1O7A3008

2. During renovation:  

during

3. After renovation:

after

 

Pink® Batts® has the right product for your building project. Always.